Homelite UT70121A User Manual

OPERATOR’S MANUALTrimmerF2020UT70121ASAVE THIS MANUAL FOR FUTURE REFERENCEYour new trimmer has been engineered and manufactured to Homelite’s high sta

10BEST CUTTINGAREADANGEROUSCUTTING AREAFig. 6ADVANCING THE STRINGADVANCING STRING USING THE EZ LINE™ TAPADVANCE SYSTEMString advance is controlled by

111IGNITION SWITCHI = ON TO RUNO = OFF TO STOPFig. 8THROTTLETRIGGERTHROTTLE INTERLOCKSTARTING AND STOPPINGSee Figures 8 and 9.OPERATIONTO START A COLD

12 WARNING:Use only original manufacturer’s replacement parts,accessories and attachments. Failure to do so cancause possible injury, poor performanc

13STRING REPLACEMENTSee Figures 12, 13, 14 and 15.1 Stop the engine and disconnect the sparking plugwire. Hold the string head and unscrew the spoolre

14The fuel cap contains a non-serviceable filter and a checkvalve. A clogged fuel filter will cause poor engine perfor-mance. If performance improves

15PROBLEM POSSIBLE CAUSE SOLUTIONIF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.1. Check spark. Remove sparking

161NOTE: The carburettor adjustment needle(s) are equippedwith plastic cap(s) which prevent anticlockwise rotationfrom the original factory adjustme

17SOUND POWER/PRESSURE AND HANDLE VIBRATION CHART FORSTRIMMERS / BRUSHCUTTERSInformation on Noise Emission per European Machine Safety Directive 98/37

18NOTES

19NOTES

2 Safety...

OPERATOR’S MANUALTrimmerF2020UT70121ARyobi Technologies GmbHItterpark 7D-40724 HildenGermanyTel.: +49 (0)2103 / 29 58 0Fax : +49 (0)2103 / 29 58 29in

3 Secure long hair so it is above shoulder level to prevententanglement in any moving parts. Keep all bystanders, children and pets at least

4Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Properinterpretation of these symbols w

5The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanationswith them, deserve your caref

6FEATURESFig. 1THROTTLE TRIGGERSILENCERGUARDSTARTER GRIPCHOKE LEVERTHROTTLE CONTROLAND REAR HANDLEFRONT HANDLEDRIVE SHAFTHOUSINGSTRING HEADGRASS DEFLE

7WING NUTFRONT HANDLEBOLTFig. 3ASSEMBLY INSTRUCTIONS:GRASS DEFLECTORSee Figure 2.1. Remove wing nut, flat washer, lock washer and bolt fromthe Owner’s

8SILENCER GUARD ASSEMBLYSee Figure 4.1. Remove silencer guard and two screws from theowner’s kit.2. Attach the silencer guard to the rear housing.NOTE

9FILLING THE TANK1. Clean surface round fuel cap to prevent contamination.2. Loosen fuel cap slowly to release pressure and to keepfuel from escaping