Homelite UT80953 User Manual download pdf (Page 16)

Page 12 — English

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Before inspecting, cleaning or servicing the machine, shut

off engine, wait for all moving parts to stop, and discon-

nect spark plug wire and move it away from spark plug.

Failure to follow these instructions can result in serious

personal injury or property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

Only the parts shown on the parts list are intended to be

repaired or replaced by the customer. All other parts should

be replaced at an authorized service center.

Before running the engine, perform the following pre-

operation steps:

Check that all bolts, nuts, etc., are securely tightened.

 Fully unwrap and straighten hose before use.

 Do not allow the high pressure hose to be kinked.

 Keephoseawayfromhotsurfacesandsharpedges.

 Donotpullunitbyhighpressurehose.

 Do not allow hose to be crushed or wrapped around

objects.

WASHING WITH DETERGENT

See Figure 17.

Use only detergents designed for pressure washers; house-

hold detergents, acids, alkalines, bleaches, solvents, flam-

mable material, or industrial grade solutions can damage

the pump. Many detergents may require mixing prior to use.

Prepare cleaning solution as instructed on the solution bottle.

place the detergent injection tube with filter

 Remove the cap from the detergent container and place

the detergent injection tube with filter in the container.

 Install the soap nozzle on the spray wand.

 Place the detergent hose into the detergent container.

Spray the detergent on a dry surface using long, even,

overlapping strokes. To prevent streaking, do not allow

detergent to dry on the surface.

Before shutting off the engine:

 Place the injection hose in a bucket of clean water.

 Flush for 1 - 2 minutes (spray clear water through the

spray wand).

 Shut off the engine.

NOTE: Shutting OFF ( O ) the engine will not relieve pressure

in the system. Pull trigger to release water pressure.

RINSING WITH THE PRESSURE WASHER

Turn off the pressure washer and shut off the water

supply. Pull trigger to release water pressure.

 Engage the lock out on the trigger handle by pushing up

on the lock out until it clicks into the slot.

 Remove the nozzle by placing hand over nozzle then

pulling back the quick-connect collar. Place nozzle in the

nozzle storage area on the machine.

 Select the right nozzle for the job. See the chart on the

previous page for selecting the appropriate nozzle.

 Start at the top of the area to be rinsed and work down,

overlapping the strokes.

MOVING THE PRESSURE WASHER

See Figure 18.

NOTE: Never lift or carry this product using the moving

handle.

 Turn the pressure washer off.

 Tilt the machine toward you until it balances on the wheels

then roll the machine to the desired position

OPERATION

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comments to this Manuals

No comments

Homelite UT80953 User Manual Page 16

Comments to this Manuals

Related products and manuals for Carwash Homelite UT80953