Homelite UT45100 User Manual

OPERATOR’S MANUALEDGER / TRENCHERUT45100SAVE THIS MANUAL FOR FUTURE REFERENCEYour edger has been engineered and manufactured to Homelite’s high standa

Page 10 FEATURESKNOW YOUR EDGER / TRENCHERSee Figure 2.The safe use of this product requires an understanding of the information on the tool and in th

Page 11 ASSEMBLYOPERATIONFig. 3COLLARWARNING:Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a s

Page 12 STARTING AND STOPPINGSee Figure 4.To start the motor: Connect the edger to power supply.  Fully depress the lock-off button. Fully dep

Page 13 MAINTENANCEWARNING:When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause produ

Page 14 841268161823571191213510917191410915EXPLODED VIEW AND PARTS LIST 1 33301261G Blade ...

Page 15 TROUBLESHOOTING 1. Plug in the power cord. 2. Check circuit breaker.1. Power cord is not plugged in or connection is loose.2. House

Page 16 WARRANTYLIMITED WARRANTY STATEMENTHomelite Consumer Products, Inc., (“Homelite”) warrants to the original retail purchaser that this HOMELITE

Page 17 NOTES

987000-3043-25-08 (REV:06)OPERATOR’S MANUALEDGER / TRENCHERUT45100UT45100SERVICEFor parts or service, contact your nearest Homelite authorized service

Page 2 Introduction ...

Page 3 IMPORTANT SAFETY INSTRUCTIONSDANGER – When using your edger, follow basic precautions.WARNING:Read and understand all instructions. Fail

Page 4 IMPORTANT SAFETY INSTRUCTIONSTurn off all controls before unplugging.Do not use tool if switch does not turn it on or off. Any tool that ca

Page 5  Be sure all guards are properly and securely attached. Replace dull or worn blade; do not attempt to sharpen. Do not attempt to sharpen

Page 6 SYMBOLSKeep Bystanders AwayTo reduce the risk of injury, user must read and understand operator’s manual before using this product.Ke

Page 7 SYMBOLSSERVICEServicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service w

Page 8 It is possible to tie the extension cord and power cord in a knot to prevent them from becoming disconnected during use. Make the knot as shown

Page 9 FEATURESFEATURESPRODUCT SPECIFICATIONSWeight ........................